6 SD Card Configuration Wizard
There are two ways to configure the FlashBack-3. Basic configuration by a wizard located on
the SD card and full configuration by logging on to a web page interface served by the unit.
FlashBack-3 adds a configuration Wizard to the SD card. Remove the card from your FB3
and inset into your PC & and double-click “FB3-Config-Wizard.” Go through the instructions
and save a file called “settings.txt” to the card. Transfer the card to your FlashBack-3 and
reboot. The new configuration is then loaded.
NB► The Wizard only changes a small number parameters. If there’s any doubt about the
state of the unit, a reset to defaults (see page 15 Section 3.8) is recommended before
you load the “settings” file.
To Next Page
Loading...
General