7 Webpage Interface
7.1 IP Address
By default the units are set for a combination of DHCP and Static IP addressing. On boot-up,
FlashBack-3 searches for a DHCP server and, if found, uses the IP address allocated by that
server. If this does not happen within 20 seconds, the unit reverts to a static IP address as
set in the "Connectivity" web page, see Section 7.9, page 27 (default is 192.168.0.123).
NB► The Wizard can be used to set a static IP address by checking the “Network
connection + server setup” option on the start page (see Section 6Error! Reference
source not found., page 18)
To Next Page
Loading...
General