To Next Page

To Previous Page

OWC Data Doubler Installation

13. Once the cable and screws from the previous steps are removed, lift the

optical drive along the top edge and gently pull it out of the optical bay as

shown below.

Caution: take care to avoid snagging or pulling the cables that were

disconnected in earlier steps. They can tear easily if they catch on the

corners of the drive, as you lift it out of the chassis.

Continue to the next page.

Other manuals for OWC data doubler

Questions and Answers:

Need help?

Do you have a question about the OWC data doubler and is the answer not in the manual?

General