OWC Data Doubler Installation
59
5. There are two ribbon cables along the left edge of the optical drive that are
attached to the logic board, with a small silver cable located beneath them
(highlighted in yellow). First, remove the small silver cable from the logic
board by gently nudging the connector in the direction shown.
Caution: this cable is easily damaged.
6. Lift up gently on each cable highlighted above in red using the included
nylon pry tool, in order to disconnect the cables from the logic board.
Caution: these cables are easily damaged.
7. Note that the cable that you disconnected in Step 5 is partly obscuring a
silver bracket held in place by a black Phillips screw. Remove the screw and
set it aside; you will need it during the reassembly process.
To Next Page
Loading...
