OWC data doubler

OWC Data Doubler Installation
70
17. Place the assembled Data Doubler into the optical bay. Be careful not to
damage any loose cables or connectors. Next, take one of the longer
screws from the kit and replace the screw that was removed in Step 5
(shown below in red).
18. Use another of the longer screws to replace the screw that was removed
in Step 3. Then, reattach the bracket from Step 4 with the original screw
that came with the laptop (shown above in blue).
19. Ax the screw removed in Step 10 to the optical drive bracket (shown
above in yellow).
20. Carefully reconnect the cable that was disconnected in Step 9, then
reconnect the ribbon cable that was disconnected in Step 11. Next,
attach the retainer that was dislodged in Step 8. If you disconnected your
battery in Step 2, reconnect it now.
21. Carefully replace the bottom cover, snapping it back into place. Ax the
10 Phillips screws that were removed earlier; make sure the three long
screws are placed back in their original locations from Step 1.
The installation process is complete. Proceed to Section 3.1 for additional
support information.