OWC Mercury Rack Pro Chapter 3 - Formatting
➃ Your drive will
appear similar to
how Disk 1 does
below. Notice that
the space on the
lower right reads as
“Unallocated.” Right
click in this space
and choose “New
Partition.”
➄ The “New Partition
Wizard” will launch. Click
“Next” to continue.
➅ Specify your partition type as
“Primary,” and click “Next.”
➆ The wizard will display the
maximum partition size for your
drive. It is strongly recommended
that you do not change the default
value. Click “Next”
To Next Page
