The Android device will disconnect with the multimeter in two seconds.
After disconnecting, the Bluetooth of the multimeter is in low-power
state. The information will be shown on APP:
The multimeter will record the current measurements and store in the
memory. After completion of the record, the Bluetooth of the
multimeter will be disabled automatically, and the Bluetooth symbol on
the multimeter screen will disappear.
Note: If the multimeter is in the process of recording data and not
finished yet, the APP can not connect with the multimeter. If you want to
interrupt the recording process of the multimeter, press and hold
until
disappear on the display, or turn the multimeter off.
(5) After completion of the record, to read the measuring data, press and
hold
until appear on the display. Reconnect the Android
device and the multimeter.
(6) In APP single view, tap on the icon on the top right, select
from the pop-up menu.
The file name start with "Offline", the following part can be customized.
(7) Tap on , APP will read the measuring data and save as a CSV
file into the Android device.
After reading, display as below:
(8) Tap on , the data will be displayed in Data Graph and Table
interface.
To Next Page
Loading...
