Owon SDS1102 - How to Measure Automatically

4.Advanced User Guidebook
38
6.
In the right menu, select Start again, the interfaces below will be displayed in
sequence. The update process will take up to three minutes. After completion, the
instrument will be shut down automatically.
7.
Press the button to power on the instrument.
How to Measure Automatically
Push the Measure button to display the menu for the settings of the Automatic
Measurements. At most 8 types of measurements could be displayed on the bottom left
of the screen.
The oscilloscopes provide 30 parameters for auto measurement, including Period,
Frequency, Mean, PK-PK, RMS, Max, Min, Top, Base, Amplitude, Overshoot, Preshoot,
Rise Time, Fall Time, +PulseWidth, -PulseWidth, +Duty Cycle, -Duty Cycle, Delay
A→B , Delay A→B
,
Cycle RMS, Cursor RMS, Screen Duty, Phase, +PulseCount,
-PulseCount, RiseEdgeCnt, FallEdgeCnt, Area, and Cycle Area.
The "Automatic Measurements" menu is described as the following table:
Function Menu
Setting
Description
AddCH1
Meas Type
(left menu)
Press to show the left menu, turn the M knob to
select the measure type, press AddCH1 again
to add the selected measure type of CH1.