Owon SDS1102 - Page 50

4.Advanced User Guidebook
45
 [Autoset] button
It's a very useful and quick way to apply a set of pre-set functions to the incoming
signal, and display the best possible viewing waveform of the signal and also works
out some measurements for user as well.
The details of functions applied to the signal when using Autoset are shown as the
following table:
Function Items
Setting
Vertical Coupling
Current
Channel Coupling
Current
Vertical Scale
Adjust to the proper division.
Horizontal Level
Middle or
±
2 div
Horizontal Sale
Adjust to the proper division
Trigger Type
Slope or Video
Trigger Source
CH1 or CH2
Trigger Coupling
DC
Trigger Slope
Current
Trigger Level
3/5 of the waveform
Trigger Mode
Auto
Display Format
YT
Force
Stop
Inverted
Off
Zoom Mode
Exit
Judge waveform type by Autoset
Five kinds of types: Sine, Square, video signal, DC level, Unknown signal.
Menu as follow:
Waveform
Menu
Sine
Multi-period, Single-period, FFT, Cancel Autoset
Square
Multi-period, Single-period, Rising Edge,
Falling Edge,
Cancel Autoset
Video signal
Type (line, field), Odd, Even, Line NO.,
Cancel
Autoset
DC level/Unknown signal
Cancel Autoset
Description for some icons:
Multi-period： To display multiple periods
Single-period： To display single period
FFT： Switch to FFT mode
Rising Edge： Display the rising edge of square waveform
Falling Edge： Display the falling edge of square waveform
Cancel Autoset：Go back to display the upper menu and waveform information
Note: The Autoset function requires that the frequency of signal should be no lower