· COPY AND PASTE
In OXI One you can copy or paste a Sequencer by holding Copy or Paste and Sequencer buttons
(1-4), corresponding to the Sequencer that you want to copy or paste. For Multitrack mode, the active
track will be copied or pasted, unless pressing its sequencer button, then it copies all tracks.
· You can also copy/paste whole Mono tracks into Multitrack tracks by pressing the first
column pad corresponding to the desired track (1-8). This is very useful to use Mono mode
power to compose and Multitrack as a storage to free up a Sequencer slot.
· Pasting from a Poly sequencer will overwrite the Sequencer mode
· Pasting from a Chord sequencer will overwrite the sequencer mode except pasting in
Poly, which you can use to fine tune your chord sequences by note.
· You can copy/paste pages of 16 steps (32, 48, etc.) onto another page.
· You can copy/paste single steps with all its parameters
Shift + Copy duplicates the current sequence’s pages onto the next ones, doubling the length of the
sequence. If the sequence is for example 80 steps long, only the remaining 48 steps would be copied
until the maximum length of 128 steps.
Shift + Paste activates Clear, it deletes all the notes and resets all parameter values to default on the
current Sequencer. What the clear resets can be modified on the Configuration screen.
· UNDO AND REDO
Undo has the last x states stored, press it repeatedly to undo unwanted takes. Press Shift
+ Redo repeatedly to undo the undo… right?
· Step input doesn’t create an undo state
· A new undo state is created with Randomizer, Extend, Clear, Duplicate, Copy and Paste.
· INIT, END and LOOP
Change the initial and final step of the active Sequencer or per track in Multitrack. You can hold Init or
End and either press any step on the grid, turn encoder 2 and 3, or press the pages buttons ,
, and . In Mono and Chord modes, double click on the page buttons to select pages
80, 96, 114 and 128.
Shift + or changes the time division of the selected Sequencer or .
To Next Page
Loading...