1.
Open the ‘Control Panel’ from the Start menu.
2.
In category view, select ‘Network and Internet’ and then ‘Network and Sharing
Centre’.
3.
Select ‘Change adapter settings’ in the side panel.
4.
Right-click the Ethernet option and select ‘Properties’.
5.
In the window that opens, navigate the list to find Internet Protocol Version 4
(TCP/IPv4). Select it and click ‘Properties’.
6.
In the TCP/IPv4 Properties window (Figure 11), select ‘Use the following IP
address’ and enter the IP address and subnet mask to use.
7.
Click ‘OK’ when finished.
Figure 11. Configuring the computer’s IP address for Ethernet data
transmission
Once the computer is configured the IP address of an RT can be found by running
NAVdisplay software; this will display the IP address of any RT connected.
Note that it is possible to change the IP address of RT systems. If the IP address has been
changed then NAVdisplay should still be able to identify the address that the RT is using,
as long as the PC has a valid IP address and this is not the same as the RT’s.
To Next Page
Loading...
