5.2.3 Display menu
Navigation:
- Open display menu: From the system status menu, press navigation button
[2].
- Scroll through the menu: Press navigation button [1] and [2].
Display menu
Status value Reading Unit Brief description
W01:Model name - Model name and type.
W02:SerialNumber - Unit serial number.
W03:Chip number - Number of the chip.
W04:OperatingHrs Measured value hh:mm Total operating hours.
W05:CoolingHours Measured value hh:mm Total cooling hours.
W06:OperatingMod Actual mode Actual operating mode on page 61.
W07:Outdoor Temp Measured value °CDB Dry bulb temperature of outdoor air.
W08:Outdoor Temp Measured value °CWB Wet bulb temperature of outdoor air.
W09:Outdoor RH Measured value % Relative humidity of outdoor air.
W10:Air Pressure Measured value mBar Measured barometric pressure.
W11:Supply Temp Measured value °CDB Measured IntrCooll® supply temperature.
W12:PowerConsump Measured value Watt
Measured actual power consumption (if optional energy meter is
selected).
W13:Amperage Measured value Amps Measured actual amperage (if optional energy meter is selected).
W14:Voltage Measured value Volt Voltage (if optional energy meter is selected).
W15:PressureLoss Measured value Pa
Dierential pressure over Oxyvap®/Filter/Coil (lter fouling can be
derived from this value).
W16:Water ow Measured value liters/min Actual supply water ow (indication).
W17:Water level Measured value Actual water level in the sump.
W18:Conductivity Measured value µS/cm Actual water conductivity in the sump.
W19:Water Temp Measured value °C Actual water temperature in the sump.
W20:WaterConsump Measured value liters and m
3
Total water consumption.
W21:CoolingRelease Parameter °C Minimum outdoor temperature for cooling mode.
W22:W-supplyValv Status Status of water supply solenoid.
W23:W-DrainValv Status Status of water drain valve.
W24:W-FrostValv Status Status of freeze protection valve.
W25:W-pump Status Status of water recirculation pump.
W26:W-disinfecti Status Status of water disinfection (various options).
60