Oxypharm NOCOSPRAY - Device Usage; Positioning and Bottle Installation

11
EN
4. USE
4.1 Posioning of the device
The Nocospray must be placed on a at and solid surface, ideally in a corner of the room to be treated and in
an elevated position, if possible
Before beginning a treatment, check that there is no obstacle within 1,5 metres of the nozzle tip.
4.2 Installaon of the bole
The installation of the bottle is carried out in the manner below.
Consider dating the product bottle before installing it onto the NOCOSPRAY 2.
Always check that the bottle contains a sucient amount of product for the desired treatment (the device does not
indicate this).
Please refer to the attached table on page54.
Steps Acon Illustraon
1
Remove the diuser nose by pressing the release button.
2
Screw the product bottle (after dating it) onto the diuser nose.
Do not screw it too tight in order to avoid irreversibly damaging the
joint.
3
Place the diuser nose back onto the device.
You should hear a “click”.
CLIC !