Oxypharm NOCOSPRAY - Programmer Mode Operation; Programmer Mode Modus Operandi

16
EN
Steps Acon Illustraon
4
Press the button on the remote control to launch
treatment.
5
A beep will sound for 15 seconds before the machine begins to
function.
Leave the room before the end of the 15seconds.
AT the end of diusion, a beep will sound.
The device will stop automatically.
15
S
If necessary, the device may be stopped during treatment by pressing
the button on the remote control again.
Respect the safety information provided on page<EX>.
4.4 Operaon in programmer mode
4.4.1 Modus operandi
It is possible to use the NOCOSPRAY 2 with a programmer (not provided) in order to dier or repeat
treatments. Follow the procedure outlined below to select the programmer mode.
Steps Acon Illustraon
1
Plug in the NOCOSPRAY 2 power cable.
Set the power switch to “1”.