Oxypharm NOCOSPRAY - Page 17

17
EN
Steps Acon Illustraon
2
Turn your nger in a clockwise direction on the pale part of the
keypad up to the value 1000, then carry out at least 3 supplementary
rotations.
x3
3
The programmer mode is engaged with 3 LEDs are illuminated in the
following manner:
• the LEDs 100 m
3
and 500m
3
are illuminated,
• the LED 250 m
3
is blinking.
4
Select the desired volume by turning in an anticlockwise direction (*).
(*) In programmer mode, the volume selected by default
is 1000m
3
.
The selected volume is displayed only when you touch the keypad.
5
Set the power switch to “0”.
Unplug in the NOCOSPRAY 2 power cable.
6
Connect the NOCOSPRAY 2 to the programmer.
Plug the programmer into a mains socket.
Set the power switch to “1”.
7
Refer to the programmer’s notice to program it.
NB: it is possible to program it beforehand.