3
GENERAL INFORMATION
MICROCHINE
HANDPIECE
Nominal Output
Speed Range: 2,500 rpm, min. to 10,000 rpm, max.
Output Torque: 14 N•mm (2.0 inch-ounces), min.
Speed Regulation: +10/-15% over Line/Load range of 0 to 14 N•mm (0 to 2 inch-ounces)
from low line to high line voltage.
Duty Cycle: Application Dependent. Continuous loading to maximum torque (Status
LED Amber in color) will cause the handpiece case to overheat.
Continuous heavy loading without a cooling period may cause damage
to the handpiece and/or the power source.
Shaft Run-Out at Collet: .13mm (0.005 inches) TIR (Total Indicator Reading) max.
EOS/ESD
Tip-To-Ground
Resistance: Less than 5 ohms.
AC Leakage : Less than 2 millivolts RMS from 50Hz to 500Hz, min.
PULSE PLATE
Output Voltage Range: 0 - 10 volts unfiltered, full wave DC.
PULSE HEAT
Output Voltage Range: 0 - 2.3 VAC RMS
To Next Page
Loading...
