Pacific Zuma - Attach Main Upright and Back Beam

Zuma Assembly and Maintenance Guide
page 9
1 2 3 4 5 6
Step 1. Attach Main Upright and Back Beam
2 - 3" bolts
4 - washers
2 - locknuts
Back Beam
C
Main Upright
Main Base
Foot Brace
1 - ¾" bolt
1 - washer
D
2 - ½ x 3¼" bolts
4 - ½" washers
2 - ½" locknuts
B
1. Attach Main Upright and
Back Beam
A. Lift the Main Upright into a vertical position.
B. With one person holding the Main Upright steady,
attach it to the Main Base using
two ½-inch by 3¼-inch bolts
four ½-inch washers
two ½-inch locknuts
Wrench tighten.
C. Attach the Back Beam to the Main Base using
two 3-inch bolts
four washers
two locknuts
Make sure the Warning label on the beam faces
upward. Wrench tighten the bolts.
D. Attach the Foot Brace to the Main Base using
one ¾-inch bolt
one washer
Wrench tighten.