28
will also be set to all. This means the policy will apply to TCP and UDP data. Ports is also
set to all.
13. Click Apply to finalize the settings.
14. By default there is a rule defined to allow priority of Voice Over IP (VOIP) data.
Dual Wan
Dual Wan allows you to use two wan ports on the router in redundancy mode. If WAN1 loses internet
access WAN2 will take over. To configure Dual Wan take the following steps.
1. Click Dual Wan.
2. Check the enable box. WAN1 will now check connectivity every 5 seconds to make sure that
it is still up and running. When WAN1 is no longer able to get onto the internet it will switch
over to WAN2. Once the router detects that WAN1 is back up it will switch back to WAN1.
To Next Page
Loading...
