64
3. There is a default pakedge user. The default password for this user is pakedgev. Click
Apply to enable the VPN with this default user.
4. You can change the username along with the password if you wish.
5. You can also add a second user to the VPN by clicking Add New Item.
6. Then you can fill in a username and password. Click Apply to finalize the settings.
7. When you connect to the VPN you will have full access to all of your devices on the
network.
Note: When you connect to the VPN you will receive an IP address from the same IP
scheme as your LAN zone. For example, if your LAN zone is setup for 192.168.1.X you will
receive an IP address from the IP range of 192.168.1.20 thru 192.168.1.30. If your network
LAN zone is setup as 192.168.10.X you will receive an IP address from the IP range of
192.168.10.20 thru 192.168.10.30.
To Next Page
Loading...
