Palas Fidas Frog - Data Export, Reporting, and Printing

5Operation and settings
3577-en-us_V1.1_08/17 21
5.9 Displaying measurements
To display a stored measurement, proceed as follows:
1. Select the Analysis menu
2. Select the desired measurement from the list
If applicable, deactivate an existing selection with deselect
3. Display the measurement with open
4. With OK, confirm the dialog window to select the measurements
The measurement is displayed.
5.10 Comparing measurements
You can compare a maximum of 5 measurements to each other.
To compare measurements, proceed as follows:
1. Select the Analysis menu
2. Select the desired measurements from the list
If applicable, deactivate an existing selection with deselect
3. Display the measurements with open
4. With OK, confirm the dialog window to select the measurements
The measurements are displayed.
5. Compare the measurements with compare
5.11 Adding pictures
Pictures can be taken with the camera on the operating element, for in-
stance to document the surroundings of the measuring site. The pictures can
be added to the measurement.
Note This function is only available while a measurement is in progress.
To add pictures, proceed as follows:
1. Touch the camera feature
The camera opens.
2. Take a picture
Multiple pictures can be taken.
3. Close the camera feature by touching X
The dialog window for adding pictures opens.
Attention: One you close the dialog window, the pictures are no
longer available.
4. Touch Add to add the desired image
Add a comment on the picture and save with Send
Multiple pictures can be added to the measurement.
Touch remove to remove individual pictures.
After adding the desired pictures, close the dialog window.
5.12 Entering comments
You can enter comments for a measurement, such as “A window was
opened”.