Revision 1.1 20
5. Is the connection to ground in power pack OK?
Is the ground connection from the tail lift to vehicle OK?
6. Check the oil level in the power pack reservoir.
7. Are there any damages on mechanical or electrical parts (such as damaged cables)?
7.1.2 On-Off L.E.D.s are on but all functions are dead
Possible malfunctions:
1. Short in hand held remote or its wire remove plug J-31.
2. Short in control box wire remove plug J-30.
After disconnecting plugs – reboot board by unplugging J-1 for 5 seconds and plug it back.
7.1.3 L.E.D.s continue to stay on, after switch is turned off
• Make sure platform is closed and stored vertically.
• Adjust the B-16 switch.
• Follow this instruction if B-16 IS NOT working:
a) Unplug J-3(w/l and f/c), J-41(B-13, B16) and J-31(Hand control), jump J-11 #4 to J-41 #GN
Keep the 3 connectors unplugged (gate will operate without plugs connected, loose auto tilt).
Open these caps to check the fuse
Please replace fuse when
metal bridge is broken
To Next Page
Loading...
Need help?
General
