Start remote control console:
1. Press the STOP-button and hold it down.
2. Press the function key FN and let both buttons go.
3. As soon as the status LED is on, the unit is ready for operation.
The console is ready for operation.
Caution!
In the event of any malfunctions during crane operation and unless
the work is interrupted immediately, there is an acute danger of
accident.
Warning!
Whenever the remote control console is not being used or there is no
visual contact with the crane, the console must always be switched
off. After finishing work always secure the unit against unauthorized
use.
If malfunctions occur, let all buttons go immediately and push the STOP-button. The remote control
console may only be used once the malfunction has been corrected by a PALFINGER service partner.
The remote control operation stops automatically if:
• There is no radio connection.
• The battery is empty.
• Any crane function was not operated for more than 5 minutes. A PALFINGER service partner can
individually set the period.
To be able to continue working, the remote control handset must be restarted.
No wireless connection
Possible causes:
• Transmitter out of reach.
Reduce the distance between transmitter and receiver.
• Receiver not switched on.
Check if receiver is on, if not switch it on.
• No valid (paired) receiver.
• Defective radio components.
Contact your PALFINGER partner.
Have any defective remote control handset immediately replaced by a PALFINGER service partner.
70
To Next Page
Loading...