YOUR PHONE
WHAT CAN I DO WHEN I’M ON A CALL?
61
4
CHAPTER
2 Select Conf. This joins the two calls in a
conference session.
3 To end the conference, press Power/
End to end all the calls.
Using Flash mode during a call
Flash mode enables you to manually
manage your calls while one or more calls
are active. This mode is often used during a
conference call when one of the calls has
ended but the other remains connected.
1 Press Send from Active Call View.
2 If the Do you want to switch to Flash
mode prompt appears, select Ye s .
3 While in Flash mode, do any of the
following:
• If you have one call in progress and
you answer an incoming second call,
press Send to swap between the
calls.
• If you have one call in progress, to
make an outgoing second call, dial the
number using any of the methods
described in Making calls
.
• If you have one call in progress and
you make an outgoing second call,
press Send after establishing a
connection with the second party to
DID
YOU
KNOW
?
Pressing Send during a
conference call usually hangs up the second
call. However, depending on your network
connection, you may instead hang up the
first call.
To Next Page
Loading...
