Page 119 Advanced HotSync® Operations
5. Click the Modem tab to display the modem settings and adjust the
options as needed. See “Conducting a HotSync operation via
modem” later in this chapter for more information.
6. Click OK.
To set the HotSync options on a Macintosh:
1. Double-click the HotSync Manager icon in the Palm folder.
2. Click the HotSync Controls tab and select any of the following
options:
Serial Port
Identifies the port that Palm Desktop software
uses to communicate with the HotSync cable.
The Palm Desktop installation software
automatically detects the number of the port to
which you connected the cable. If necessary,
you can change the port selection.
Note:
Your
handheld cannot share this port
with an internal modem or other
device. See “Palm m100 components”
in Chapter 1 if you have trouble
identifying the serial port.
Speed
Determines the speed at which data is
transferred between your handheld and Palm
Desktop software. Try the As Fast As Possible
rate first, and adjust downward if you
experience problems. This setting allows Palm
Desktop software and your handheld to find
and use the fastest speed.
To Next Page
Loading...
Need help?
General
