Chapter 5 Page 134
4. Click OK.
To prepare a Macintosh for a modem HotSync operation:
1. Confirm that the Macintosh modem is connected and turned on,
and that no communications applications, such as fax or telephony
software, or AppleTalk networking are running on that serial port.
Note:
Make sure the Macintosh is disconnected from all online
services, such as CompuServe and America Online
(AOL). This helps to avoid conflicts with the serial port.
2. Double-click the HotSync Manager icon in the Palm folder.
3. Click the Serial Port Settings tab.
4. Under Check for handheld connection using, click Modem Setup.
5. Adjust the following options as needed.
Setup
String
Identifies the setup string for your particular
modem. Not all modems require a setup string.
Refer to your modem manual and enter the setup
string if recommended by the manufacturer.
Modem
Identifies the type of modem connected to your
Macintosh. If your modem does not appear on
the list, use the Hayes Basic setting, or choose
Custom to enter a command string. Refer to the
manual that came with your modem to find the
appropriate command string.
To Next Page
Loading...
Need help?
General
