8 Using Your Treo 700w Smartphone
CHAPTER 1 Getting Started
Installing the battery
1. Use one hand to press the battery door release and use the
other hand to slide the battery door downward to remove it
from your smartphone.
2. Align the battery contacts with the phone contacts inside
the battery compartment.
3. Insert the battery into the compartment at a 45-degree
angle and then press it into place.
4. Slide the battery door onto the back of the smartphone
until it clicks into place.
5. Your smartphone screen turns on and the Treo screen appears.
Wait for the progress bar on the Treo screen to fill.
6. When the Windows Mobile screen appears, tap the screen with the
stylus to begin the setup process, and then follow the onscreen
instructions to set up your smartphone.
Tip
If your smartphone
does not turn on, you
need to connect it to
the AC charger to
charge it. Before you
can complete the
setup process, you
must also do a soft
reset. See
“Performing a soft
reset” on page 197.
Tip
You can buy an extra
battery as a spare for
long airplane trips or
periods of heavy data
use. Be sure to use
batteries from Palm
only.
Battery door
release
Notch
Phone
contacts
Battery
contacts