Adding shot marks to clips
Adding shot marks (
M
) will make it easier to find
the clips you are looking for.
1
Tilt the Operation lever in the
directions to move the yellow frame to the
clip for which a shot mark is to be added.
2
Press the USER button to which the shot
mark function has been allocated. (Page 55)
To release a shot mark, repeat the above steps.
It is not possible to add shot marks to clips •
recorded using a consumer camcorder model.
Select the card slot for playback
You can switch the SD memory card slot for
playback.
1
Press the SLOT SELECT button when the
THUMBNAIL screen is displayed in the PB
mode.
2
Tilt the OPERATION lever in the up, down,
left, and right directions to select the SD
memory card slot for playback. You can play
back still images as well.
VIDEO:
Movie playback
PICTURE:
Still picture playback
3
Push the OPERATION lever.
To Next Page
Loading...
