Lens attachment and detachment
Check that the power switch is set to OFF.•
Attaching a lens to the camera
■
1
Turn the lens rear cap and body cap in the direction indicated by the arrows and remove.
Body cap
Lens rear cap
Do not insert fingers into the mount.•
Lens detachment
button
2
Line up the lens attachment marks (red) on the camera and lens, and then turn the lens in the
direction indicated by the arrows until it audibly clicks into place.
Do not press the lens detachment button while attaching •
the lens.
Damage may occur to the lens attachment if the lens is •
not at right angles to the camera during attachment.
Ensure that the lens is attached properly.•
3
Remove lens cap.
Remove lens cap prior to recording.•
Precaution for use (continued)
To Next Page
Loading...
