Panasonic AG-CX10 - Focusing (Manual Focus); White Balance Adjustment

Manual recording
50
DVQX2103 (ENG)
AE level (exposure compensation)
1 Select the [SCENE FILE] menu → [AE LEVEL] → [ON].
2 Select the [CAMERA] menu → [SW MODE] → [REAR RING] → [IRIS/AE LEVEL].
3 When the <AUTO/MANU> switch is set to manual mode, use one of the
following operations to switch one of iris, gain, or shutter speed to auto.
≥ Press the <IRIS> button to switch to auto iris mode.
≥ Press the <GAIN> button to switch to auto gain mode.
≥ Press the <SHUTTER> button to switch to auto shutter mode.
4 Rotate the rear ring.
@
NOTE
0 When manual iris mode is enabled, the iris is adjusted when the rear ring is turned.
Focusing (manual focus)
1 Switch to <MANU> with the <AUTO/MANU> switch to enter manual mode.
2 Press the <FOCUS A/M/¶> button to switch to manual focus mode.
[AF] and [MF] switch each time you press the button. The focal point goes to infinity after
you press and hold the button, and then the manual focus mode is engaged.
3 Rotate the focus ring.
White balance adjustment
Follow the steps below to adjust the white balance
automatically.
≥ White balance/black balance adjustment is done
using the [AWB] USER button function. Make the
settings beforehand.
It is set in the [USER6] button icon at the time of
purchase.
To display the operation icon, touch and hold the
screen for approximately 2 seconds while the camera recording screen is being displayed.
F1:
AWB
AREA
FACE DETECT
ZEBRA
MENU
COUNTER RESET
F2:
＊＊＊＊＊
F3:
＊＊＊＊＊
F4:
＊＊＊＊＊
F5:
＊＊＊＊＊
F6:
＊＊＊＊＊
AG-CX7_CX8_CX10-DVQX2103_eng.book 50 ページ ２０２０年１月６日 月曜日 午後２時４８分