– 106 –
Chapter 4 Shooting — Setting the time data
3
Set [TCG/TCR] in the main menu → [OUTPUT SEL] → [TC OUT].
@@
NOTE
t If you set [TC OUTPUT REF] to [VIDEO OUT] in the main menu → [OUTPUT SEL], the input time code will be output to match the video output delay.
Connecting and setting the genlock and time code input/output
The relationship of the connecting and settings between the genlock and time code input/output is shown in the table.
When the genlock input and the camera output phase match, l is displayed, and when they do not match, × is displayed.
r When the camera recording format is 1080P, 1080i
Camera usage conditions
Image and standard signals
supplied externally
SDI VIDEO SDI VIDEO
Genlock input 1080i SD (480i/576i)
Camera settings [GL PHASE] [HD SDI] [COMPOSITE] [HD SDI] [COMPOSITE]
Genlock input and camera
output phase
SDI output (HD)
l
90H advance
l
90H advance
Video output and SDI output
(SD)
90H delay
l
90H delay
l
Time code output
l l l l
r When the camera recording format is 1080/23.98PsF
Camera usage conditions
Image and standard signals supplied externally SDI
Genlock input 1080/23.98PsF
Camera settings [GL PHASE] [HD SDI]
Genlock input and camera output phase
SDI output (HD)
l
Video output and SDI output (SD)
×
Time code output
l
r When the camera recording format is 720P
Camera usage conditions
Image and standard signals
supplied externally
SDI VIDEO SDI VIDEO
Genlock input 720P SD (480i/576i)
Camera settings [GL PHASE] [HD SDI] [COMPOSITE] [HD SDI] [COMPOSITE]
Genlock input and camera
output phase
SDI output (HD)
l
120H advance
l
120H advance
Video output and SDI output
(SD)
120H delay
l
120H delay
l
Time code output
× ×
l l
r When the camera recording format is 480i/576i
Camera usage conditions
Image and standard signals
supplied externally
SDI VIDEO
Genlock input SD (480i/576i)
Camera settings [GL PHASE] Disabled
Genlock input and camera
output phase
SDI output (HD) None
Video output and SDI output
(SD)
l
Time code output
l
Setting and displaying the counter
If you display the counter using the <COUNTER> button, the counter value is displayed on the time code display of the viewnder/LCD monitor. Counter
value is displayed as “hour:minute:second.frame”. The counter value is also displayed during playback.
You can set either of two types in the main menu → [DISPLAY SETUP] → [REC COUNTER].
[TOTAL]: The camera will continuously count until reset using the <RESET> button. Even if you replace the P2 card or turn off the power, the value will
be maintained.
[CLIP]: Each time you start recording the counter value will clear and the count will start from 0. You can shoot always while checking the recording time
of the clip you are currently shooting.
@@
NOTE
t If the <RESET> button is pressed while the counter value is displayed, the counter value is reset. It will start again from 0.
t The counter value is displayed by the frame unit.
To Next Page
Loading...
