Panasonic AJ-PX270 - For Wireless Module Other than AJ-WM30; For Wired LAN

– 181 –
Chapter 9 Network Connection — Preparing for connection
For wireless module other than AJ-WM30
Connect the wireless module other than AJ-WM30 (optional) to the camera. The grip belt can be removed.
Turn off the power of the camera before connecting or disconnecting the wireless module.
Fig. 1
<OPEN> button <USB2.0 HOST> terminal
Cord cap
Cord cap compartment
USB 2.0 extension cable
Wireless module
Fig. 2 Fig. 3
Fig. 4 Fig. 5 Fig. 6
1
Press the <OPEN> button and remove the cover by sliding it in the direction of the arrow. (Fig. 1)
2
Connect the USB 2.0 extension cable (optional: type A male/female, 0.2 m) to the <USB2.0 HOST> terminal. (Fig. 2)
3
Remove the cord cap inside the removed cover (Fig. 3), pass the USB 2.0 extension cable there, and slide the cover to close. (Fig.
4)
The removed cord cap can be stored in the cord cap compartment inside the cover.
4
Pass the USB 2.0 extension cable through the grip belt compartment. (Fig. 5)
5
Connect the wireless module. (Fig. 6)
The wireless module can be stored in the grip belt.
@@
NOTE
t For details on wireless modules that can be connected, refer to the support desk at the following website.
http://pro-av.panasonic.net/en/sales_o/p2/server/4glte.html
http://pro-av.panasonic.net/en/sales_o/p2/server/wireless_module.html
For wired LAN
Connect a LAN cable.
LAN cable (optional)
1
Connect the LAN cable to the <LAN> terminal on the rear side.