Panasonic AJ-PX270 - Page 174

– 174 –
Chapter 8 Connecting to External Devices — Connection function via <USB2.0 DEVICE> or <USB3.0 HOST> terminal
Writing back to the P2 card from a storage device (import)
Importing from a [TYPE S] storage device or [P2STORE] by partition
You can import (write back to a P2 card from as storage device) to a P2 card with the same part number as the source card by partition (card).
1
Insert a P2 card that will serve as the input destination.
Make sure to insert a formatted P2 card.
2
Connecting a storage device.
3
Select [STORAGE] in the main menu → [CLIP] → [EXPLORE] to display the explorer screen.
4
In the explorer screen, display the partition thumbnails to be imported.
5
Select [IMPORT] in the main menu → [CLIP].
6
Place the cursor on the P2 card slot number of the import destination and press the control stick.
Start importing by selecting [YES] in the conrmation message.
[COPY COMPLETED!] will be displayed when importing is completed.
@@
NOTE
t Importing to a P2 card that is different from the source P2 card may result in incomplete clips depending on the clips. In this case, use the
reconnection function to recongure the clips. For details, refer to “Reconnecting incomplete clips” (page 115).
t You can select whether to perform verication at the time of copying in the main menu → [CLIP] → [STORAGE COPY SETUP] → [VERIFY].
t You cannot import by partition to a P2 card of a different model. Perform copying by clip instead.
Copying to a P2 card by clip
You can specify a storage device clip and copy it to a P2 card.
1
Open the storage device thumbnail screen.
2
Select the clip you want to copy.
3
In the main menu → [CLIP] → [COPY] → [STORAGE] list, move the cursor over the copy destination and press the control stick.
Start importing by selecting [YES] in the conrmation message.
[COPY COMPLETED!] will be displayed when copying is completed.