– 54 –
Chapter 4 Shooting — Adjusting the white and black balance
r Messages displayed in the viewnder and LCD monitor
Status Message Remark
During adjustment [ABB ACTIVE]
Adjustment completed [ABB OK]
f The adjusted value is automatically stored in
memory.
@@
NOTE
t During black balance adjustment, the aperture is set to automatically shut out light.
t During recording, black balance cannot be adjusted.
t During the automatic black balance execution, recording to the P2 card is not performed by pressing the REC button.
t The gain switching circuit is automatically switched during black balance adjustment. Flicker or noise sometimes appears on the viewnder screen and
LCD monitor. This is not a malfunction.
Black balance memory
Values stored to memory are saved even if the camera is turned off.
To Next Page
Loading...
