7 – 29Aquarea air/water heat pump – Installation manual for compact systems 03 / 2013
7
Electrical
installation
Electrical installation
Installing the wired remote control
7.3 Installing the wired remote control
Component Quantity Comment
Remote control 1
Remote control cable 1 15 m long
Screw (M4 × 30 mm
machine screw)
3 For installing the remote control on an
outlet (embedded connection cable)
Screw (M4 × 14 mm
self-tapping screw)
3 Installing the remote control on the
wall (exterior connection cable)
Included accessories
Warning! Please follow these instructions to prevent damage and problems:
Do not change the length of the cable for the wired remote control.
Install the wired remote control cable at least 5 cm away from other
electric cables.
Do not install the wired remote control cable in the immediate vicinity
of water or condensate pipes.
The installation location must be dry.
The wired remote control must be installed so that it is not exposed
to direct sunlight.
Mount the wired remote control in as level a location as possible
to prevent the wired remote control bending.
Observe the minimum clearances as shown in the following diagram:
To Next Page
Loading...
