Panasonic Aquarea WH-MDF06E3E5 series - Laying Visible Cables

7 – 32 Aquarea air/water heat pump – Installation manual for compact systems 03 / 2013
Electrical installation
Installing the wired remote control
Laying visible cables
7.3.2 Laying visible cables
1
Remote control cable
2
Upper clamp
3
Upper cover
4
Plug connector (CON1)
5
Lower cover
6
Screw
7
Lower clamp
1
Cable outlet to the top
2
Lower cover
3
Tabs
4
Remote control cable
5
Notches
1
5
4
3
2
Laying visible cables
1
3
4
5
6
7
2
Danger!
Lay the cable as shown in
WKHÀJXUHDERYHVRWKDWWKH
housing of the remote control
can be closed securely.
³ Use the two supplied M4 × 14 screws to secure the lower cover of the
remote control to the wall. When tightening the screws, ensure that
the screw heads not sitting proud. Use only the supplied screws.
³ Select an outlet direction of your choice for the remote control cable
and use a wire cutter to open one of the notches provided for this pur-
pose in the upper cover in accordance with the outlet direction.
³ Route the remote control cable in the lower cover as shown in the
ÀJXUHEDVHGRQWKHRXWOHWGLUHFWLRQVHOHFWHG
³ Fasten the connection of the remote control cable to the plug
connector (CON1) in the upper cover of the circuit board. Ensure
that is securely attached.
³ Secure the cover to the lower cover of the remote control using the
clamps provided.