1 – 6 Aquarea air/water heat pump – Installation manual for compact systems 03 / 2013
Introduction
Symbols used | Tools required
The warnings in this manual absolutely must be heeded, as they are
safety-critical. The symbols have the following meanings:
We recommend that you use the following tools:
The following components must be provided by the customer:
Phillips-head screwdriver
Spirit level
Electric drill
Set of spanners
Knife
Tape measure
Multimeter
Torque wrench, 39.2 Nm
Torque wrench, 58.8 Nm
Gas leak detector
2-way directional valve set
3-way directional valve set
Analogue room thermostat (e.g.
RAA20 Siemens) or program-
mable room thermostat
(e.g. REV200 Siemens)
Anchoring to prevent tipping over
Dirt trap (mesh width at least
500 to 600 μm)
Propylene glycol antifreeze
mixture
)OXVKPRXQWHGER[IRUÀWWLQJ
the wired remote control
Heating circuit mixer closed-
loop control
Dew point monitor
Device for draining the system
Insulation for pipelines
1.4 Symbols used
1.5 Tools required
1.6 To be provided
by customer
NOTE Further information
Warning! Material damage if not observed
Danger! Danger of fatal injury from electric shock if not observed
Danger! Danger of fatal injury or damage to health if not observed
³
,GHQWLÀFDWLRQRIDVWHS
To Next Page
Loading...
