Panasonic Aquarea WH-SXC09H3E5 - Installing and Connecting the Remote Controller

184 Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
Installation
6
Hydrokit and mono-bloc systems F Generation
CLOSE OPEN N
1 2 3 4
5 6
7 8
9 10
11 12
13 14 15 16
17 18
19 20
21
22 23
CLOSE OPEN CLOSE OPEN N
COOL
HEAT N L
N
2-way valve 3-way valve E-Heating
element hot
water tank
Room
thermostat
Temperature
sensor for hot
water tank
Overload
protection for hot
water tank
External control
signal
Solar 3-way
valve
Solar pump
station
i
Note
For further information about connecting the optional on-site accessories, please refer
to the following sections: → 4.7.2 External interfaces (inputs/outputs), p. 65 and
→ 4.8.5 Recommended on-site accessories, p. 90.
6.8.3 Installing and connecting the remote controller
i
Note
This section describes installation and connection of the remote controller only for models of the
J and H Generation
Detailed installation instructions for the F and G generation models are given in the planning
manual for bi-bloc systems or mono-bloc systems from 2014 as well as in the installation
instructions and in the service manual of the respective device.
CAUTION
Danger of electrical shock due to unprofessional installation
Unprofessional installation of the remote controller can result in electrical shock or re.
► Respect the connecting conditions for the remote controller (→ 4.7.2.1 External interfaces
(J and H generation), p. 66). Take special care to connect the remote controller not to
the terminals for the power supply, but to the correct terminals.
► Do not install the cable of the remote controller in the direct vicinity of coolant or
condensate pipes.
ATTENTION
Danger of damage or malfunctions due to unprofessional installation
Unprofessional installation of the remote controller can result in damage to or malfunctions in the
control signals.
► Install the remote controller at a site where no sunshine and condensation humidity can
occur because the remote controller is not proofed against vapour or water.
► Mount the remote controller on as a at a site as possible, to avoid any bending and
damage to the display.