– 165 –
Chapter 8 Connecting to External Devices — Connecting the camera and the iPad/Android terminal
6
If the [ENCRYPT KEY] is set, enter the password, and select [Enter].
7
Check the network connection.
Once connected, is displayed on the screen of the camera.
@@
NOTE
t ENCRYPTION in WEP is not supported.
r Setting items in [NETWORK PROPERTY] when set to [INFRA(SELECT)]
[ENCRYPTION] [WPA-TKIP], [WPA-AES], [WPA2-TKIP], [WPA2-AES], [NONE]
(Factory setting: [WPA-AES])
[ENCRYPT KEY] WPA2 encryption key
(Factory setting: [01234567890123456789abcdef])
[DHCP] Setting the DHCP function
f [OFF]: Does not use the DHCP function.
f [CLIENT]: Acquire from DHCP when connecting with [TYPE] set to [INFRA(SELECT)] or
[INFRA(MANUAL)].
f [SERVER]: When connecting by setting [TYPE] to [DIRECT], enable the DHCP server function of the
camera. (Cannot be selected.)
(Factory setting: [SERVER])
[IP ADDRESS] IP address of the camera
(Factory setting: [192.168.0.1])
[SUBNET MASK] Subnet mask
(Factory setting: [255.255.255.0])
When entering the wireless access point (SSID) manually
1
Select the [NETWORK SETTINGS] menu → [NETWORK PROPERTY] → [TYPE] → [INFRA(MANUAL)].
2
Set each item in the [NETWORK SETTINGS] menu → [NETWORK PROPERTY] as necessary.
f For details of setting, refer to “Setting items in [NETWORK PROPERTY] when set to [INFRA(MANUAL)]”.
3
Select the [NETWORK SETTINGS] menu → [NETWORK SEL] → [WLAN].
4
From the [NETWORK SETTINGS] menu → [NETWORK PROPERTY] → [SSID], enter the SSID of the wireless access point to
connect.
5
Select SSID, and select [Enter].
Setting is completed when the [ENCRYPT KEY] (encryption key, password) is not set.
6
If the [ENCRYPT KEY] is set, enter the password, and select [Enter].
7
Check the network connection.
Once connected, is displayed on the screen of the camera.
@@
NOTE
t ENCRYPTION in WEP is not supported.
r Setting items in [NETWORK PROPERTY] when set to [INFRA(MANUAL)]
[ENCRYPTION] [WPA-TKIP], [WPA-AES], [WPA2-TKIP], [WPA2-AES], [NONE]
(Factory setting: [WPA-AES])
[ENCRYPT KEY] WPA2 encryption key
(Factory setting: [01234567890123456789abcdef])
[DHCP] Setting the DHCP function
f [OFF]: Does not use the DHCP function.
f [CLIENT]: Acquire from DHCP when connecting with [TYPE] set to [INFRA(SELECT)] or
[INFRA(MANUAL)].
f [SERVER]: When connecting by setting [TYPE] to [DIRECT], enable the DHCP server function of the
camera. (Cannot be selected.)
(Factory setting: [SERVER])
[IP ADDRESS] IP address of the camera
(Factory setting: [192.168.0.1])
[SUBNET MASK] Subnet mask
(Factory setting: [255.255.255.0])
When connecting from the history
History of connection is saved when connected to a wireless access point. Connection is easily made with the same setting as before when connecting
from the history.
1
Select the [NETWORK SETTINGS] menu → [CONNECTION HISTORY] → [SELECT].
The connection history is listed with the SSID of the wireless access point.
To Next Page
Loading...
