– 73 –
Chapter 4 Operation — Menu setting contents
Menu setting contents
[THUMBNAIL] menu
Performs conrmation or deleting of the recording clip.
This menu can be set when the thumbnail screen is displayed.
[PLAYBACK]
[SLOT SEL]
Selects a clip to be displayed on the thumbnail screen.
[ALL SLOT] Displays the clips recorded on all the SD cards in each card slot.
[SLOT1] Displays only the clips recorded on the SD card in card slot 1.
[SLOT2] Displays only the clips recorded on the SD card in card slot 2.
(Factory setting: [ALL SLOT])
[RESUME PLAY]
Select if the playback is to start from the position the playback has stopped or not.
[ON] Plays back from the position where playback has stopped.
[OFF] Always starts the playback from the beginning of the clip.
(Factory setting: [OFF])
[CLIP]
The clip can be protected or copied to a different SD card.
[PROTECT] [SELECT] Protect the clip so it is not mistakenly deleted.
Select the clip to protect, and set the protect.
[DELETE] [ALL] Deletes all the clips displayed in the thumbnail screen.
The clip that is not displayed in the thumbnail screen is not deleted.
[SELECT] Select the clip to delete, and delete it.
[COPY] [ALL] Copies all clips to a different SD card.
[SELECT] Select the clip to copy, and copies to a different SD card.
[INFORMATION] Displays the detailed information of the clip.
@@
NOTE
t The clip recorded in the MOV format cannot be copied.
[SYSTEM SETTINGS] menu
Sets the system in general.
[SYSTEM MODE]
For the combination that can be set, refer to “Selecting the resolution, codec, and frame rate for recording video”, “Selecting the resolution and frame
rate of the RAW output”.
[FREQUENCY]
Sets the system frequency.
The items that can be set are as follows.
f [23.98p], [24.00p], [25.00p], [29.97p], [50.00p], [59.94p], [50.00i], [59.94i]
(Factory setting: [23.98p])
@@
NOTE
t The camera will restart when the setting is changed.
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [MAIN CODEC] is set to AVCHD format, different clips with system frequency in
59.94 Hz system (23.98p, 59.94p, 59.94i) and the ones in 50 Hz system (50.00p, 50.00i) cannot be recorded in a single SD card. Prepare an SD card
for each system of system frequency (59.94 Hz system and 50 Hz system). [FORMAT ERROR CARD <SLOT 1>]/[FORMAT ERROR CARD <SLOT
2>] alert is displayed when the system frequency systems are different.
[SDI RAW]
Sets the RAW output resolution from the <SDI OUT> terminal.
[OFF] Does not perform RAW output.
[S35 5.7K]
Performs the RAW output of the 5760×3072 pixels using all the pixels of the image sensor.
Allows shooting up to 30p.
[CROP 4K]
Performs the RAW output of the 4096×2160 pixels by cutting out the center section of the image sensor.
Allows shooting up to 60p. Angle of view will change.
To Next Page
Loading...
