– 74 –
Chapter 4 Operation — Menu setting contents
[CROP&MIX 2K]
Performs the RAW output of the 2048×1080 pixels by cutting out the center section of the image sensor and performing the
pixel mixing read.
This allows high-speed shooting up to 240p. Angle of view will change.
(Factory setting: [OFF])
@@
NOTE
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [FREQUENCY] is set to [50.00i]/[59.94i], this is xed to [OFF].
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [FREQUENCY] is set to [50.00p]/[59.94p], [S35 5.7K] cannot be selected.
t Following conditions apply when set to anything other than [OFF].
‑ Recording to an SD card with the camera is not possible.
‑ The [SYSTEM SETTINGS] menu → [COLOR SETTINGS] → [MAIN] will be xed to [V-Log].
‑ The [CAMERA SETTINGS] menu → [EI] → [MODE] will be xed to [ISO].
‑ The thumbnail screen is not displayed.
‑ [E.I.S.], [D.ZOOM], [PRE REC], [REC CHECK], [DEL LAST CLIP], [SLOT SEL], [SDI COLOR], and [COLOR BARS] assigned to the USER button
will not operate.
‑ The [OUTPUT SETTINGS] menu → [SDI OUT] → [SDI REC REMOTE] and the [OUTPUT SETTINGS] menu → [HDMI OUT] → [HDMI REC
REMOTE] will not operate.
‑ The time code information is not output in the image output from the <HDMI> terminal.
[SENSOR MODE]
Sets the drive mode of the image sensor.
[S35 5.7K] Uses the entire pixels of the image sensor.
[S35 MIX 2.8K] Performs pixel mixing read of 2.8K from the entire image sensor.
This allows high-speed shooting up to 120p.
[4/3 CROP&MIX 2.2K] Performs the pixel mixing read of 2.2K by cropping the Four Thirds image circle from the center of the image sensor.
This allows high-speed shooting up to 240p. Angle of view will change.
(Factory setting: [S35 5.7K])
@@
NOTE
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SENSOR MODE] → [4/3 CROP&MIX 2.2K] is set
‑ The sensitivity will be lower than when [S35 5.7K] or [S35 MIX 2.8K] is set.
‑ The items that can be set in the [CAMERA SETTINGS] menu → [EI] → [NATIVE ISO] will be [400 ISO] or [1250 ISO].
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SDI RAW] is set to anything other than [OFF], this cannot be set.
[MAIN PIXEL]
Sets the main recorder’s number of recording pixels.
The items that can be set are as follows.
f [4096x2160], [3840x2160], [2048x1080], [1920x1080], [1280x720]
(Factory setting: [4096x2160])
@@
NOTE
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SDI RAW] is set to anything other than [OFF], this cannot be set.
[MAIN CODEC]
Sets the recording codec of the main recorder.
f MOV le
[420LongGOP 150M] 4:2:0 (8 bits) LongGOP 150 Mbps
[420LongGOP 100M] 4:2:0 (8 bits) LongGOP 100 Mbps
[420LongGOP 50M] 4:2:0 (8 bits) LongGOP 50 Mbps
[422LongGOP 150M] 4:2:2 (10 bits) LongGOP 150 Mbps
[422LongGOP 100M] 4:2:2 (10 bits) LongGOP 100 Mbps
[422LongGOP 50M] 4:2:2 (10 bits) LongGOP 50 Mbps
[422ALL-I 400M] 4:2:2 (10 bits) ALL-Intra 400 Mbps
[422ALL-I 200M] 4:2:2 (10 bits) ALL-Intra 200 Mbps
[422ALL-I 100M] 4:2:2 (10 bits) ALL-Intra 100 Mbps
f AVCHD le
[AVCHD PS] 4:2:0 (8 bits) LongGOP 25 Mbps
[AVCHD PH] 4:2:0 (8 bits) LongGOP 21 Mbps
[AVCHD HA] 4:2:0 (8 bits) LongGOP 17 Mbps
[AVCHD PM] 4:2:0 (8 bits) LongGOP 8 Mbps
(Factory setting: [422LongGOP 150M])
@@
NOTE
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SDI RAW] is set to anything other than [OFF], this cannot be set.
To Next Page
Loading...
