Panasonic AU-EVA1 - [AUDIO SETTINGS] Menu

– 89 –
Chapter 4 Operation — Menu setting contents
@@
NOTE
t It will be xed to [REC RUN] when the [CAMERA SETTINGS] menu → [FPS] → [VFR SW] → [ON] is set.
t It will be xed to [FREE RUN] when the [REC SETTINGS] menu → [PRE REC] → [ON] is set.
t It will be xed to [REC RUN] when the [REC SETTINGS] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is set.
[DF/NDF]
Sets the count method for the time code generator.
Enabled only when the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [FREQUENCY] → [59.94i]/[59.94p]/[29.97p] is set.
[DF] Uses the drop frame mode.
[NDF] Uses the non-drop frame mode.
(Factory setting: [NDF])
@@
NOTE
t It will be xed to [NDF] when the [REC SETTINGS] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is set.
[UB MODE]
Selects the user bits mode. User bits information is recorded in the clip. Also, it is output as LTC UB, VITC UB of the SDI signal.
[FRAME RATE] Selects the image information (such as frame rate) of the camera.
[USER] Selects the user bits set in [SET UB].
[TIME] Selects the local time. (hh, mm, ss)
[DATE] Selects the local date and time. (YY, MM, DD, hh)
[CLIP NAME] ASCII character code of the CAM INDEX (A to Z) recorded as a MOV format le goes into MSB. Also, three digit ASCII
character code of the REEL COUNT recorded as the MOV format le goes into LSB. (Example: A123=0x41 0x31 0x32 0x33)
It will record even if the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [MAIN CODEC] is not set to the MOV format.
(Factory setting: [USER])
[TC IN/OUT SEL]
Sets the input/output of the <TC IN/OUT> terminal.
[TC IN] Sets to the time code input.
[TC OUT] Sets to the time code output.
(Factory setting: [TC IN])
[TC OUT REF]
Sets the output delay of the time code that is output from the <TC IN/OUT> terminal.
[RECORDING] Outputs the recording time code without delay. This is used when performing simultaneous recording on two cameras with
the time code of this camera as the master.
[SDI OUT] Matches to output image from the <SDI OUT> terminal. Outputs without delay when video is not output from the <SDI OUT>
terminal.
(Factory setting: [RECORDING])
[AUDIO SETTINGS] menu
Sets the input/output function of audio.
[AUDIO CH SETTINGS]
[CH1 IN SELECT]
Sets the audio to be recorded in the audio channel 1.
[INT(L)] Records the audio from the built-in microphone <L>.
[INPUT1] Records the input signal from the <AUDIO INPUT 1> terminal.
(Factory setting: [INT(L)])
[CH2 IN SELECT]
Sets the audio to be recorded in the audio channel 2.
[INT(R)] Records the audio from the built-in microphone <R>.
[INPUT1] Records the input signal from the <AUDIO INPUT 1> terminal.
[INPUT2] Records the input signal from the <AUDIO INPUT 2> terminal.
(Factory setting: [INT(R)])
[CH1 MIC LOWCUT]
Enables/disables the lowcut lter for audio channel 1.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])