– 90 –
Chapter 4 Operation — Menu setting contents
[CH2 MIC LOWCUT]
Enables/disables the lowcut lter for audio channel 2.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[CH1 LIMITER]
Enables/disables the limiter when the method to adjust the audio input level for audio channel 1 is manual.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[CH2 LIMITER]
Enables/disables the limiter when the method to adjust the audio input level for audio channel 2 is manual.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[HEAD ROOM]
Sets the headroom (standard level).
The items that can be set are as follows.
f [18dB], [20dB]
(Factory setting: [20dB] (when [AREA SETTINGS] is set to [AREA 1]/[AREA 2]), [18dB] (when [AREA SETTINGS] is set to [AREA 3]))
[AUDIO INPUT]
[INPUT1 LINE/MIC SEL]
Sets the audio input signal from the device connected to the <AUDIO INPUT 1> terminal.
[LINE] Sets this when an audio device is connected.
[MIC] Sets this when an external microphone is connected.
(Factory setting: [LINE])
[INPUT2 LINE/MIC SEL]
Sets the audio input signal from the device connected to the <AUDIO INPUT 2> terminal.
[LINE] Sets this when an audio device is connected.
[MIC] Sets this when an external microphone is connected.
(Factory setting: [LINE])
[INPUT1 MIC POWER]
Enables/disables the phantom power supply for the external microphone connected to the <AUDIO INPUT 1> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[INPUT2 MIC POWER]
Enables/disables the phantom power supply for the external microphone connected to the <AUDIO INPUT 2> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[INPUT1 MIC LEVEL]
Sets the input level of the external microphone connected to the <AUDIO INPUT 1> terminal. Enabled when the external microphone is connected and
[INPUT1 LINE/MIC SEL] of [AUDIO INPUT] is set to [MIC].
The items that can be set are as follows.
f [-40dB], [-50dB], [-60dB]
(Factory setting: [-60dB])
[INPUT2 MIC LEVEL]
Sets the input level of the external microphone connected to the <AUDIO INPUT 2> terminal. Enabled when the external microphone is connected and
[INPUT2 LINE/MIC SEL] of [AUDIO INPUT] is set to [MIC].
The items that can be set are as follows.
f [-40dB], [-50dB], [-60dB]
(Factory setting: [-60dB])
[INPUT1 LINE LEVEL]
Sets the audio input level of the audio device connected to the <AUDIO INPUT 1> terminal. Enabled when the audio device is connected and [INPUT1
LINE/MIC SEL] of [AUDIO INPUT] is set to [LINE].
To Next Page
Loading...
