Panasonic AU-EVA1 - Page 91

– 91 –
Chapter 4 Operation — Menu setting contents
The items that can be set are as follows.
f [4dB], [0dB]
(Factory setting: [4dB])
[INPUT2 LINE LEVEL]
Sets the audio input level of the audio device connected to the <AUDIO INPUT 2> terminal. Enabled when the audio device is connected and [INPUT2
LINE/MIC SEL] of [AUDIO INPUT] is set to [LINE].
The items that can be set are as follows.
f [4dB], [0dB]
(Factory setting: [4dB])
[AUDIO OUTPUT]
[MONITOR OUT]
Sets the audio channel and the format to be output from the headphone terminal.
[CH1] Outputs the signal for audio channel 1 as monaural.
[CH2] Outputs the signal for audio channel 2 as monaural.
[STEREO] Outputs the signals of the audio channel 1 and the audio channel 2 as stereo.
[MIX] Mixes the signals of the audio channel 1 and the audio channel 2 and outputs as monaural.
(Factory setting: [STEREO])
[MONITOR DELAY]
Sets if the audio from the headphone terminal is to be delayed to match the video on the LCD monitor.
[LIVE] Outputs without delay.
[RECORDING] Matches to the video on the LCD monitor.
(Factory setting: [LIVE])
[MONITOR VOL]
Adjusts the level of audio output from the headphone terminal.
The items that can be set are as follows.
f [0]…[100]
(Factory setting: [70])
[REC BEEP SOUND]
[MODE]
Sets if the beep sound is generated when starting or stopping the recording.
[OFF] The beep sound is not generated.
[START] The beep sound is generated only when the recording is started.
[STOP] The beep sound is generated only when the recording is stopped.
[START&STOP] The beep sound is generated when the recording is started and stopped.
(Factory setting: [OFF])
[VOLUME]
Sets the volume of the beep sound when starting or stopping the recording.
The items that can be set are as follows.
f [HIGH], [MED], [LOW]
(Factory setting: [MED])
[ALARM]
[BATTERY END]
Sets if the alarm is to be sounded when the remaining battery level is exhausted.
The items that can be set are as follows.
f [HIGH], [MED], [LOW], [OFF]
(Factory setting: [MED])
[MEDIA END]
Sets if the alarm is sounded when the remaining recordable capacity of the SD card is exhausted.
The items that can be set are as follows.
f [HIGH], [MED], [LOW], [OFF]
(Factory setting: [MED])
@@
NOTE
t Volume of the alarm during system error is xed to [MED].