Panasonic AUTO-LOGIC EASA-PHONE KX-T1450BA

How to Operate from a Remote Phone
Resetting the ICM Tape for Future Messages
To record new Incoming Messages from the beginning of the tape, after the recorded
messages are played back or while they are being piayed;
^ 1 Press “3”.
•The unit will rewind the tape to the
beginning and a beep tone will be
heard when the tape has been reset.
DEF
3
If you have used Memory Playback
After all the messages
have been played back.
DEF
3
DEF
3
1 Press “3”.
•The unit will rewind the tape to the beginning of the
newly-recorded messages and a beep will be heard.
2 Press “3” again.
•A beep tone will be heard and the
future messages will be recorded
from the beginning of the ICM tape.
After you have used
the Memory Playback.
If you have reset the tape by mistake
V
ABC
2
1 Press “2” after the tape has been reset (one-beep), then hang up.
•The unit will advance the tape to the end of the recorded
messages.
Monitoring Room Sound
You can monitor sounds In the room where the unit is installed.
1
Call your unit and press the Code No. during the OGM.
r
L
JKL
5
2
Press “5” right after you hear the beep tones indicating the
number of the recorded messages.
•You can listen for 30 seconds.
•To listen further, press “5” again within 10 seconds of hearing
one beep.
-16-