Panasonic AUTO-LOGIC EASA-PHONE KX-T1450BA

Troubleshooting Guide
Problem Cause & Remedy
•The unit does not work when I press any
buttons.
^•I cannot remove the cassette from the unit.
Plug in the AC adaptor then switch ^
the power on.
J
^The unit has been set to the Answer mode,
but no Incoming Messages are recorded.
•The OGM or ICM cassette is cut or^
is not inserted. Replace the cassette
with a new one.
•The OGM is recorded improperly.
Record a new OGM. ^
^The unit does not function. However, the
beep sounds 6 times and the
ANSWER/CALLS indicator flashes on and off
^quickly.
•OGM cassette might be broken. ^
Replace it with a new one.
•Clean the heads. (See page 20.)
J
^While recording an Outgoing Message, the
beep sounds 6 times.
L
Re-record your Outgoing Message. ^
Speak clearly and loudly, and do not
pause for over 2 seconds while
recording. j
^When the Outgoing Message or the
Incoming Message tape is played back, the
sound level is low, even if the VOLUME
y^control is turned up fully.
•Clean the Heads. (See Maintenanc^
instruction on page 20).
J
have played back all the recorded
messages and I want to record the next
phone call after the last previously recorded
^message.
•Wait for 7 seconds. The unit will be^
ready to record the next phone call.
•In case of the remote operation, just
hang up. y
press the button of a remote phone, but
the unit does not respond.
V_^_
•Make sure that you are entering your'
correct Code number.
•Record the Outgoing Message in a
quiet place. ^
I
Some Incoming Messages have not been
^ recorded up to their end.
Set the CPC switch to “B”. ^
(See page 4.) ^
I
The ICM tape continues to run after a caller
^ hangs up.
1
Set the recording time selector to
“1 MIN”.
-19-