89
Web screen configurations
(continued)
IR ID
Configure the unit’s remote control ID.
The settings for this item correspond to the [CAM1] to
[CAM4] buttons on the wireless remote control.
Setting value: CAM1, CAM2, CAM3, CAM4
Factory settings: CAM1
CAM/BAR
Switch between color bar display and camera image
display on the monitor and the web setup screen.
Setting value: Camera, Colorbar
Factory settings: Camera
● When the color bar is displayed, a test tone (1 kHz)
is output according to the Audio setting in the
camera menu.
Note
Bars Type
Change the type of color bar to display. (page 50)
Setting value: Type1, Type2
Factory settings: Type2
Bars Title
Set camera title (page 68) display to Off/On for when
the color bar is displayed.
Factory settings: Off
● The camera title is not displayed when the camera’s
OSD menu is displayed in the Web screen.
Note
z OSD Mix
This item’s setting is reflected when the [Set] button is
pressed.
OSD Off With Tally
This is used to enable or disable the function for clearing
the OSD menu displays when the tally signal is received
by a command or contact.
When the tally signal is released, the original OSD menu
displays are restored.
Factory settings: Off
OSD Status
“Off” or “On” is set here for the status display which
appears during AWB operations.
Factory settings: Off
z Protocol
This item’s setting is reflected when the [Set] button is
pressed.
Model Select
Set the protocol model for standard serial communication.
Do not select “Reserved1” to “Reserved7”.
Setting value: SEVIHD1, SBRC300, SBRCZ330,
Reserved1 to 7
Factory settings: SEVIHD1
To Next Page
Loading...
