9
Selecting the units
When performing the operations
using the wireless remote control
1 Press the [CAM1], [CAM2], [CAM3] or [CAM4]
button.
The unit’s status display lamp blinks green when a signal
matched by the remote control ID has been received,
and it blinks orange when a signal that is not matched by
the remote control ID has been received.
When performing the operations using the controller
When using an AW‑RP50, AW‑RP120 or AK‑HRP200:
Refer to the Operating Instructions of the controller.
Selecting the shooting modes (scene files)
■Types of shooting modes
The unit has four preset shooting modes, each of which
corresponds to a set of circumstances in which the subject
will be shot.
Select the mode that satisfies the shooting conditions and
suits your preferences.
The settings can be changed by menu operations.
● The results of the white balance and other adjustments
are stored in the memory separately by shooting mode.
Be absolutely sure to select the shooting mode before
making any adjustments.
● If “Full Auto” has been selected as the setting for
Scene on the camera menu, for example, all the auto
settings will be turned on, and manual operations will
no longer be possible for some of the items.
Note
Full Auto
Adjust the shutter speed, aperture, and white balance
automatically.
Manual1
The settings of your preferences can be established
in line with the shooting scene, lighting and other
conditions.
Manual2
The settings of your preferences can be established
in line with the shooting scene, lighting and other
conditions.
Manual3
The settings of your preferences can be established
in line with the shooting scene, lighting and other
conditions.
To Next Page
Loading...
