Streaming format
Makes settings for H.264 or H.265 images for use in SRT
transmission.
The setting is confirmed with the [Set] button.
Refer to the explanation for H.264 (→ page 102) or H.265
(→ page 104) for information about Image capture size, Frame rate
and Max bit rate(per client).
<NOTE>
• Streaming format settings cannot be changed during SRT
transmissions.
• When [IP(UDP)] of [Tracking Data Output] is set to [On], video
transmission via IP may be delayed or the video may suffer frame
loss. (→ page 122)
We recommend [IP(UDP)] of [Tracking Data Output] is set to [Off]
during SRT transmission.
• When the frame frequency is 24/23.98Hz, you cannot set to the
SRT(H.264), or SRT(H.265) modes.
z MPEG2‑TS over UDP
Make settings for MPEG2-TS over UDP transmission.
<NOTE>
• In order to receive the images being transmitted by the camera, enter
the following URL in the application or service.
- For Unicast
udp://@[unicast ipaddress]:[unicast port]
- For Multicast
udp://@[multicast ipaddress]:[multicast port]
Transmission type [Unicast, Multicast]
Sets the transmission type for MPEG2-TS over UDP transmission as
either Unicast or Multicast.
Factory settings: Unicast
Unicast address(IPv4)
Sets the Unicast address used for MPEG2-TS over UDP
transmission.
Specify this IP address on the receiving application or service.
Factory settings: 192.168.0.3
Unicast Port [1024 to 50000]
Sets the Unicast port number used for MPEG2-TS over UDP
transmission.
Specify this port number on the receiving application or service.
Factory settings: 7002
Multicast address(IPv4)
Sets the Multicast address used for MPEG2-TS over UDP
transmission.
Specify this IP address on the receiving application or service.
Factory settings: 239.192.0.20
Multicast Port [1024 to 50000]
Sets the Multicast port number used for MPEG2-TS over UDP
transmission.
Specify this port number on the receiving application or service.
Factory settings: 32004
Multicast TTL/HOPLimit
The same as H.264 [Multicast TTL/HOPLimit] (→ page 104).
Push UDP [Enable, Disable]
When Push UDP has been set to Enable, MPEG2-TS over UDP
transmission starts automatically when the camera is started.
Factory settings: Enable
Streaming format
Make settings for H.264 images used for MPEG2-TS over UDP
transmission.
The setting is confirmed with the [Set] button.
Refer to the description of H.264 (→ page 102) for information about
Image capture size, Frame rate, and Max bit rate(per client).
<NOTE>
• Streaming format settings cannot be changed during MPEG2-TS
over UDP transmissions.
• When [IP(UDP)] of [Tracking Data Output] is set to [On], video
transmission via IP may be delayed or the video may suffer frame
loss. (→ page 122)
We recommend [IP(UDP)] of [Tracking Data Output] is set to [Off]
during MPEG2-TS over UDP transmission.
106 107
Web screen configurations (continued)
To Next Page
Loading...
