Audio setting screen [Audio]
Configure audio settings.
<NOTE>
• Images and audio are not synchronized. Therefore, images and audio
may be slightly out of sync.
• The audio may skip depending on the network environment.
z Setting status
Audio
Audio
The setting status of audio input is displayed.
Input Type
The setting status of the audio input type is displayed.
Volume Level CH1
Set the volume of audio output (CH1).
This is only enabled when [Audio] is set to [On].
Volume Level CH2
Set the volume of audio output (CH2).
This is only enabled when [Audio] is set to [On].
Plugin Power
The setting status of audio plugin power is displayed.
Audio over IP
Audio transmission
The setting status of audio data IP transmission is displayed.
Audio bit rate
The bit rate setting status for audio data via IP transmission is
displayed.
z Audio
The setting is confirmed with the [Set] button.
Audio [Off, On]
Turn audio input off/on.
Factory settings: Off
Input Type [Mic, Line]
Mic Set the microphone input.
Line Set the line input.
This is only enabled when [Audio] is set to [On].
Factory settings: Line
Volume Level CH1 [–36dB to +12dB]
Set the volume of audio output (CH1).
This is only enabled when [Audio] is set to [On].
Factory settings: 0dB
Volume Level CH2 [–36dB to +12dB]
Set the volume of audio output (CH2).
This is only enabled when [Audio] is set to [On].
Factory settings: 0dB
Plugin Power [Off, On]
Turn the plugin power for the audio off/on.
This is only enabled when [Audio] is set to [On].
This is only enabled when [Input Type] is set to [Mic].
Factory settings: Off
110
Web screen configurations (continued)
To Next Page
Loading...
