Skin Detail [Off, On]
This function smooths skin and produces a more beautiful image.
This is only enabled when [Detail] is set to [On].
Factory settings: Off
Skin Detail Effect [0 to 31]
The skin of human subjects appears smoother the larger the setting
value.
This is only enabled when [Detail] is set to [On] and [Skin Detail] is set
to [On].
Factory settings: 16
Gamma Mode
[Normal, HD, Cinema1, Cinema2, Still Like]
Select the type of gamma curve.
Normal Standard gamma characteristic.
HD HD (High Definition) video gamma characteristic.
Cinema1 High contrast gamma characteristic.
Cinema2 Sedate gamma characteristic.
Still Like Sets the gamma characteristics for a digital still
camera image tone.
Factory settings: Normal
Gamma [0.30 to 0.75]
Adjust the gamma correction level.
Specifying smaller values results in a gentler gamma curve for the
slope of low-brightness areas and sharper contrast.
Specifying larger values results in an expanded gradient for dark
areas and produces brighter images. The gamma curve for low-
brightness areas will be steeper, and contrast will be softer.
Factory settings: 0.45
DRS [Off, Low, Mid, High]
Set the DRS function which performs correction when video with high
light/dark contrast is displayed.
You can select from a [Low], [Mid], or [High] effect level.
Factory settings: Off
Knee Mode [Off, Auto, Low, Mid, High]
Set the operating mode for gradation compression (knee).
Off Turn the knee function off.
Auto Enable the knee function, and set the knee point and knee
slope automatically.
Low, Mid,
High
Enable the knee function, and manually set the knee point
and knee slope in three steps.
Factory settings: Auto
<NOTE>
• When [DRS] is enabled, the knee setting is disabled.
White Clip [Off, On]
Turn the white clip function off/on.
Factory settings: On
White Clip Level [90% to 109%]
Set the white clip level.
This is only enabled when [White Clip] is set to [On].
Factory settings: 109%
<NOTE>
• When [Knee Mode] is set to [Auto] and the value of [White Clip
Level] is changed, the knee value will also change.
DNR [Off, Low, High]
Set the digital noise reduction level for outputting bright, clear images
without noise, even at night and low-light conditions.
When [Low] or [High] is selected, noise can be eliminated.
However, image lag may increase.
Factory settings: Low
116
Web screen configurations (continued)
To Next Page
Loading...
